Samsung Galaxy S23 Ultra Wireless Charging Coil and Loudspeaker Replacement

Written By: Alex Diaz-Kokaisl
  • Comments: 0
Samsung Galaxy S23 Ultra Wireless Charging Coil and Loudspeaker Replacement

Difficulty

Moderate

Steps

7

Time Required

30 - 45 minutes

Introduction

This is a prerequisite-only guide! This guide is part of another procedure and isn't meant to be used alone.

  1. Mpv2PsbCdI1iW6Wb
    Mpv2PsbCdI1iW6Wb
    oj5xEmMeYhOpTSBr
    qfgottJDieSAVxSq

    • Use the pointed end of a spudger to pry up and disconnect the NFC antenna press connector from the motherboard.

    • Repeat for the wireless charging coil press connector.

    • To re-attach press connectors, carefully align and press down on one side until it clicks into place, then repeat on the other side. Don't press down on the middle. If the connector is misaligned, the pins can bend and cause permanent damage.

  2. h5cMIyxpAtqjbKU4
    h5cMIyxpAtqjbKU4
    V4QoZv3VfMBsKpaU
    e3Xe11ICRIVOP6VV

    • The wireless charging coil is lightly adhered to the battery.

    • Insert an opening pick between the right edge of the wireless charging coil and the battery.

    • Slide the pick along the right edge to separate the adhesive.

  3. YWBGWevJudPUNtxB
    YWBGWevJudPUNtxB
    aN12mHIkZCFnugfP

    • Insert an opening pick between the top edge of the wireless charging coil and the frame.

    • Slide the pick toward the right edge to separate the remaining adhesive.

  4. MqBoxonnnfOluifG

    • Use a Phillips screwdriver to remove the five 3.5 mm-long screws securing the NFC antenna and charging coil.

  5. A5ENg165DhNqsGVf

    • Use a Phillips screwdriver to remove the six 3.5 mm screws securing the loudspeaker.

  6. AUNWPUyerrpSCGAn
    AUNWPUyerrpSCGAn
    O1a6hFfuIO3JDxai

    • Insert the pointed end of your spudger between the upper right corner of the loudspeaker and the frame.

    • Pry up to unclip the loudspeaker from the frame.

    • Don't pry against the battery. Use protrusions in the frame for leverage.

    • During reassembly, press around the perimeter of the loudspeaker to clip it to the frame.

  7. 1FHZvGkxEADnOK2w
    1FHZvGkxEADnOK2w
    kOOFuS1g3BJGNd6D
    jrAtNKEbQKxi4JXe

    • Grab and remove the NFC, wireless charging coil, and loudspeaker from the frame.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Alex Diaz-Kokaisl

Member since: 16/01/22

163004 Reputation

0 comments